Button Sewing - Janome Sewing Machine Instruction Book

z
x
c
q w e
r
z x c v b n
m ,
• Bridge stitch
Patterns #55 to #58 in mode 3 are extender stitches
which are used to insert straight stitches after a stitch
pattern.
The extender stitches #57 and #58 inherit the stitch
length and needle drop position of a previous pattern
in programmed pattern combination. To see more
detailed information about extender stitch, please
refer to page 51.
Example: Inserting 2 counts of the straight stitch after
a stitch pattern.
z Select pattern 10 (mode 2).
Press the memory key.
Pattern 10 is memorized.
x Select pattern 57 (mode 3).
Press the memory key.
Pattern 57 (2 counts of straight stitch) is
memorized.
c Two counts of straight stitch are inserted between
blind stitches.

Button Sewing

q Stitch pattern:
w Needle thread tension:
e Presser foot:
r Feed dog:
z Lower the feed dog.
x Match the holes of button to the horizontal slot on the
presser foot.
c Lower the foot to hold the button in place.
v Adjust the stitch width so the needle will enter the left
hole of the button.
b Turn the handwheel so that the needle will enter the
right hole of the button. Readjust the stitch width if
necessary.
n Stitch several times.
m After you finish sewing, cut the threads but leave 3˝ to
4˝ of threads at the end.
, With a hand sewing needle, draw the top thread to the
reverse side of the fabric and knot the threads.
* After the button sewing is completed, raise the feed
dogs for normal sewing.
32
MODE 1: 7
3 to 7
Satin stitch foot F
Dropped