HP Integrity rx2600 Operation And Maintenance Manual page 105

2. Follow the prompts on the screen to modify the LAN settings:
IP Address
MP Host name
Subnet, Gateway
Web Console Port Number
LAN hardware configuration (optional)
The Link State controls the speed at which the MP card communicates with the network.
Select auto-negotiate to allow the system to make the fastest possible connection.
The MP card will also negotiate to half or full duplex. This is the default,
recommended in most cases.
Select 10BaseT to force the MP card to operate at the slower 10BaseT speed if
necessary for your network configuration. For example, if your network contains
both 10BaseT and 100BaseT connections, and you want the system to communicate
with the other 10BaseT connections, you must force it to operate at the slower speed.
NOTE: If you force the MP card to operate at 10BaseT speed, it also operates at half duplex.
Make sure that your switch or hub is also in half duplex mode.
In all options, to:
Change the setting, type the appropriate information, then press
Confirm your selections, type
3. Execute the
your system's MP firware revision.
MP firmware E.02.10:
xd
Non destructive tests:
1. Parameters checksum
2. I2C access (get Power Monitor status)
3. LAN access (PING)
4. Modem selftests
5. Secondary I2C access (get System status)
Type R to reset the MP or [Q] to quit the diagnostic menu.
-> Choice:
MP firmware E.02.20 or higher:
XD
Diagnostics Menu:
Non destructive tests:
P - Parameter checksum
I - I2C access (get Power Monitor Status)
L - LAN access (PING)
M - Modem selftests
Destructive tests:
R - Restart the MP
Enter menu item or [Q] to Quit:
4. Select option
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
Y
xd
command to reset the MP card. The following is displayed, depending on
3 L
or to ping the LAN and verify the LAN settings are correctly configured.
Enter
then press at the confirmation prompt.
System Configuration
Enter
.
3–31