Log Set Installation - Regency P48-LP Owners & Installation Manual

Read the instructions below carefully and refer to the diagrams.
If logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The gas log kit (Part # 370-930) contains the following pieces:
a) 02-83 Center Cross Log
b) 02-84 Right Side Cross Log
c ) 02-85 Front Left Side Log
d) 02-86 Front Right Side Log
e) 02-87 Left Side End Log
f ) 02-88 Rear Log
g) 02-89 Middle Right Side Log
h) 02-90 Right Side End Log
i) Embers (Lava)
h) Vermiculite
02-88
02-87
02-85
02-83
The "02" reference numbers (i.e. 02-83) are molded
into the rear of each log.
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Sprinkle the vermiculite all over the top of the base brick panel.
3) Line up the two holes on the underside of Log 02-88 with the 2 pins
at the rear of the grate and position into place.
Regency P48 Zero Clearance Direct Vent Gas Fireplace

LOG SET INSTALLATION

902-338
902-339
902-340
902-341
902-342
902-343
902-344
902-345
902-154
902-179
02-90
02-89
02-86
02-84
Pins
02-88
4) Place Log 02-85 on the front left side of the burner. Position the right
end of the log into the pin on the burner and rest the left end of the
log between the 1st grate post and the front tab.
1st Grate Post
5) Line up the two holes on the underside of Log 02-86 with the 2 pins
on the right side of the burner and position into place.
02-88
02-86
02-85
Pins
INSTALLATION
02-88
02-85
Pin
Tab
25