HP Guardian Errors Manual page 250

sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4 = The subsystem organization name;
sysmsg[17]
sysmsg[18]
sysmsg[19]
sysmsg[20] FOR n = Up to 80 bytes of text
If the call to the STOP procedure deletes the process name from the process-pair directory,
the operating system sends this message:
sysmsg[0]
sysmsg[1] FOR 3
sysmsg[4]
sysmsg[5]
sysmsg[19])
sysmsg[6] FOR 4
sysmsg[10]
sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4 = Subsystem organization (8 bytes);
sysmsg[17]
sysmsg[18]
sysmsg[19]
sysmsg[20] FOR n = Text (up to 80 bytes)
If an external process caused the termination, the stop message is changed as follows:
sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4 = Process ID of the process that caused
This message indicates that neither member of the process pair exists.
For information about completion codes, refer to
Response The response, if any, is application dependent.
-6 PROCESS DELETION (ABEND)
Cause (C-series-format system message only) A process was deleted because of a call to the
process-control ABEND procedure, or because the deleted process encountered a trap condition
and was aborted by the operating system.
The abend message is sent to the ancestor of the process and the ancestor of the job (GMOM).
Format The two forms of the abend message are:
If one member of the process pair is deleted or if the deleted process was not named, the
operating system sends the following message:
sysmsg[0]
sysmsg[1] FOR 4
sysmsg[5]
sysmsg[19])
sysmsg[6] FOR 4
sysmsg[10]
sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4 = The subsystem organization name;
250 System Messages
= The completion code
= Termination information; 0 if the user
did not supply information
for HP products,this is HP
= The subsystem number
= The subsystem version
= The length of text in bytes
= -5
= The name of the deleted process
= -1
= The header size (header ends at
= Process processor time in microseconds
(a FIXED value)
= The job ID; 0 if process has no GMOM
= The completion code
= Termination information, 0 if the user
did not supply information
for HP products, this is HP
= Subsystem number
= Subsystem version
= Length of text in bytes
= Completion code defaults to 6
= Creator access ID
the termination
= -6
= Process ID of deleted process
= Header size (header ends at
= Process processor time in microseconds
(a FIXED value)
= The job ID; 0 if process has no GMOM
= The completion code
= Termination information; 0 if the user
did not supply information
Table 15 (page 260).