HP Guardian Errors Manual page 213

Effect The header token ZSPI-TKN-LASTERR is set to this error number, and the requested operation
is not completed.
Recovery For the first cause, use a larger buffer. For the second cause, recovery is
application-dependent.
-6 ZSPI-ERR-XSUMERR
Cause The current buffer checksum does not match the checksum computed on return from the last
SPI call. This error suggests that the buffer has been modified or damaged.
Effect The header token ZSPI-TKN-LASTERR is set to this error number, and the requested operation
is not completed.
Recovery Using a debugging tool such as the Inspect debugger, check for corruption of the buffer
contents.
-7 ZSPI-ERR-INTERR Internal error
Cause This internal error should not occur unless the SPI software malfunctions. Specific causes
include:
SSGET attempted to return a token value when the program had requested a token attribute
(such as length, offset, address, or count).
SSGET attempted to return an undefined token attribute.
On returning, SSGET or SSPUT attempted to set a used length greater than the buffer length.
SSPUT received an error when calling SSGET to obtain the default subsystem ID
(ZSPI-TKN-DEFAULT-SSID) from the SPI message header.
Effect The header token ZSPI-TKN-LASTERR is set to this error number, and the requested operation
is not completed.
Recovery Report the problem to your service provider, supplying a reproducible test case.
-8 ZSPI-ERR-MISTKN Token not found
Cause This error can occur for one of the following reasons:
The token requested in a call to SSGET was not found.
An attempt was made to put a ZSPI-TKN-ENDLIST token into the buffer, but no corresponding
list token was found.
Effect The header token ZSPI-TKN-LASTERR is set to this error number, and the requested operation
is not completed.
Recovery Corrective action depends on the application. Check for program logic errors in scanning
the buffer. Also check to see whether the token is positioned outside the current list or preceding
the current position.
-9 ZSPI-ERR-ILLTKN Illegal token code or map
Invalid checksum
Error Codes 213