3. WATER VALVE
1) Unplug the icemaker or disconnect the power source.
2) Close the water supply tap.
3) Remove the Top Panel and Door.
4) Disconnect the Water Supply Inlet from the Water Valve.
5) Remove the Mesh Filter from the Water Valve.
6) Clean the Mesh using a brush.
7) Refit the Mesh and Water Supply Inlet in their correct positions.
8) Open the water supply tap.
9) Plug in the icemaker or connect the power source.
10) Check for leaks.
11) Refit the panels in their correct positions.
Coil
Fig. 6
Do not remove
24
Filter