Adjustment Guides - Genie PowerMax 1200 Operation & Maintenance Manual

6
Maintenance and Adjustments

ADjUSTMENT GUIDES

Door closing force is FACTORY set and requires no adjustment
for normal operation.
• NEVER adjust the force settings to compensate for damage,
including an unbalanced door, binding door track, or broken
spring.
• Perform monthly a CONTACT REVERSE TEST. See page 8.
Force Settings
Force settings are pre programmed at the factory and "learned"
during the Open/Close Limit settings steps (see pages 6-7). For normal
use, these settings should not need adjustment with this unit.
However, conditions possibly requiring adjustment are:
1. Doors with very stiff weather seals.
2. Doors that start down, STOP, and reverse before closing.
3. Doors that start up, but STOP before they completely open.
Force Adjustment
Action
1
Press and hold
both up and
down buttons
2 seconds or until round
LED turns RED.
2
Press either
until you reach
desired setting.
3
PROGRAM
Press and
release.
SET
4
Press either
until you
reach the
desired setting.
5
PROGRAM
Press and
release.
SET
FORCE SETTINGS DONE
18
G999-393 Manual-ScrewBeltChain-EN indd 18
C AU T IO N
LED Indication/Result
RED BLUE
OFF OFF
Flashes 3 Times
The Current UP FORCE SETTING
will display. SEE CHART IN NEXT
COLUMN.
USE CHART IN NEXT COLUMN
LOCKS IN SETTING.
Then the New
DOWN FORCE
BLUE
Flashing
SETTING will display.
USE CHART IN
NEXT COLUMN
BLUE
LOCKS IN SETTING.
Both LEDs turn
BLUE
BLUE then OFF
BLUE
confirms both
FORCE Settings are reset.
LED indicator colors:
Force Level
Force Level 1
Force Level 2
Force Level 3
Force Level 4
Force Level 5
Force Level 6
Force Level 7
Force Level 7
Force Level 9
OFF
BLUE
OFF
OFF
Blue Purple Red
OFF
Powerhead LEDs
LONG LED ROUND LED
BLUE
Off
BLUE
Off
BLUE BLUE
Off PURPLE
PURPLE
Off
PURPLE
PURPLE
Off RED
RED
Off
RED RED
(continued next page)
7/13/12 10 17 AM