Step 7 Installing Logs And Ember Material; Shutter Settings; Positioning The Logs; Placing The Ember Material - Quadra-Fire QVI-30FB Owner's Manual

Step 7. Installing Logs and Ember Material

Shutter Settings

Burner
___________________________________________
QVI-30FB
___________________________________________

Positioning the Logs

The logs have been packaged separately. Refer to the
installation instructions that accompany this manual. Save
the log instructions with this manual.
If sooting occurs, the logs or glowing embers might need
to be repositioned slightly to avoid excessive flame
impingement.

Placing the Ember Material

Two separate bags of ember material are shipped with this
gas appliance. The bag labeled Glowing Ember (050-721)
is standard glowing ember material. To place the ember
material:
• Remove the glass door from the unit (see Figure 12).
PULL AND
RELEASE
CLIPS TO OPEN
Figure 12. Glass Assembly
Step 8. Installing Trim
Surrounds
Combustible materials MUST
NEVER overlap onto the front
face.
1. Find the coiled low voltage wires
and ON/OFF switch attached to
outer right side of the insert (see
Figure 14).
2. Disconnect the ON/OFF switch
from the low voltage wire leads,
and insert the ON/OFF switch
through the hole at the upper
right corner of the surround - it
will be retained in the hole.
NG LP
3/8" Full Open
LOCATING
TABS
Figure 14.
Quadra-Fire • QVI-30FB • 2020-900 Rev. H • 9/07
EMBER MATERIAL
(TOP SURFACE,
AND FRONT)
Figure 13. Placement of the Ember Material
• Place a dime size piece of GLOWING EMBER mate-
rial near port holes in burner top, sides and front (see
Figure 13).
• Space dime size ember pieces about a 1/2 inch apart.
Never press embers into burner ports. Do not cover burner
ports. Place dime size pieces around front and sides of
burner pan.
• Save the remaining ember materials for use during fire-
place servicing. The embers provided are sufficient for 2
to 4 applications.
• Place MYSTIC EMBERS over burner surface and around
base of the burner, do not cover any burner port holes.
Can be used on floor of firebox for a realistic ash-bed.
• Replace the glass door on the fireplace.
• Re-install and latch the decorative front.
ON/OFF
SWITCH
SURROUND
WITH TRIM
BURNER PAN
FIREBOX
19