Mt3 Emulation - Printek MtP Series Programmer's Manual

Selecting Mt3 Emulation allows applications written for the Printek Mt3 series printers to operate properly.
When using this emulation in an MtP400, the printer matches the print width of the Printek Mt3 by only
allowing printing to occur on the leftmost 2.83 inches (576 dots) of the print line.
For information on selecting emulations using Escape Sequences, please refer to "Selecting Emulations" on
page 3. For information selecting emulations through the printer's control panel set up, please refer to the
printer's Operator's Manual.
The following summary lists the commands supported when Mt3 Emulation is selected. For more detailed
information, please refer to the Mt3 Programmer's Manual.
Communications (RS-232C Serial Interface Only)
End of Text
Acknowledge (Transmitted by Printer)
Printer Idle (Transmitted by Printer)
Transmitter On (Transmitted by Printer)
Transmitter Off (Transmitted by Printer)
Character Size and Line Spacing
Select Character Pitch
Set Printer to 12 cpi
Set Printer to 21 cpi
Set Printer to 21 cpi
Double High On
Double High Off
Set Text Line Spacing
Character Attributes
Select Emphasized Mode
Character Sets
Select Extended Character Set
Horizontal Position
Carriage Return
Backspace
Horizontal Tab
Vertical Position
Line Feed
Variable Size Line Feed
Variable Size Reverse Line Feed
Vertical Tab
Form Feed

Mt3 Emulation

ETX
ACK
EOT
XON (DC1)
XOFF (DC3)
ESC k n
SO
SI
NORM (DC4)
FS
GS
ESC a n
ESC U n
ESC F n
CR
BS
HT
LF
ESC J n
ESC Q J n
VT
FF
31