Install The Leg Press Cable - Precor move beyond S3.15 Assembly Instructions Manual

S3.15 Leg Press Option Assembly Instructions

4. Install the Leg Press Cable

A. Lower the Leg Press Arm and rest it on the floor.
B. Attach the Leg Press Cable 130193 to the base of
the Leg Press using
one -inch x 3 -inch hex head bolt
two washers
one ½-inch locknut
Wrench tighten.
C. Remove one 3 -inch pulley on the Seat Base
Upright. Feed the cable through the seat base and
under the pulley. Reattach the 3 -inch pulley using
one 2 -inch hex head bolt
two ½-inch shoulder spacers
one locknut
Wrench tighten.
D. Remove the 3 -inch pulley from the adjustable
Pulley Bracket. Feed the cable around it and
reattach it using
one 2¼-inch zinc hex head bolt
two zinc washers
one zinc locknut
Wrench tighten.
Step 4. Install the Leg Press Cable
1 - " x 3¾" bolt
B
2 - washers
1 - locknut
1 - 2¾" bolt
2 - ½-inch shoulder spacers
1 - locknut
Pulley assemblies
3½-inch Pulley (used on gray
painted parts)
1 - bolt
2 - shoulder spacers
1 - locknut
1 2
Lower the Leg
A
Press Arm.
C
1 - 2¼" zinc bolt
D
2 - zinc washers
1 - zinc locknut
3½-inch Pulley (used on
titanium parts)
1 - zinc bolt
2 - zinc washers
1 - zinc locknut
3 4 5 6
page 10