Route The Cable - Precor Vitality Series Assembly Manual

1. Insert the lower end of the 14 mm guide rod into the retaining ring at the bottom of the
weight tower frame.
Note: The end of the guide rod with the screw hole in it should face up. Also, you may need to
loosen the set screws in the retaining ring to seat the guide rod completely.
2. Slide the 389 mm support tube onto the guide rod from the top down.
3. Slide the support ring onto the guide rod, followed by the rubber bumper.
4. Slide the 5 lb (2.5 kg) add-on weight onto the guide rod, making sure that the groove is at the
top end of the weight.
5. Attach the top of the guide rod to the bracket at the top of the weight tower frame using:
1 – M10 x 25 mm hex head bolt
1 – 11 mm flat washer
6. Fully tighten the M8 set screw in the retaining ring using the S4 hex key.

Route the cable

1. Remove the cable socket and the cable end cover from the end of the cable.
2. Screw one end of the cable assembly into the top of the weight stack stem.
CAUTION: Be sure to complete at least seven (7) turns/threads into the fitting.
3. Pull the cable through the top of the weight tower frame, over the top of the dual pulleys,
and under the cable retaining brackets on the pulleys. Thread the cable down through the
tower frame.
4. At the bottom of the weight tower frame, thread the cable through the lower pulley. Pass the
cable from the weight tower to the seat frame assembly and thread it around the horizontal pul-
ley.
Note: Be sure that the cable retaining brackets do not interfere with the travel of the cable.
Figure 6
5. Thread the cable through the lower vertical pulley on the seat frame assembly, then over the
upper pulley on the movement arm and under the upper pulley on the seat frame.
6. Slide the cable end cover over the cable end and down the cable a few inches. Slip the ball at
the end of the cable into the slot in the socket, then insert the cable anchor into the slot.
7. Position the cable end cover over the socket, then insert the bolt through the holes in the
cover, the socket, and the anchor. Attach the nut to the bolt and tighten completely.
CAUTION: Complete at least seven (7) turns/threads into the fitting before you tighten the
jam nut.
Tighten all frame mounting hardware
1. Check that the weight tower and seat frame are sitting evenly on the floor.
2. Start at the weight tower, and tighten the mounting hardware at the base support, then at
the cross support.
3. On the seat frame, tighten the mounting hardware at the base support, and then at the cross
support.
|
©2021 Precor Incorporated VSL Multi-Press
Figure 7
| |
Assembly Guide P/N CWR247777-102 ENU 31 July 2021
|
3