Audio In Settings - Pioneer DVR-920H Operating Instructions Manual

The Initial Setup menu
• S-Video – Almost the same quality as RGB, but can
give better results if you are using a long SCART
cable.
• RGB – If your TV is compatible, this setting gives the
best picture quality.
AV2/L1 In
• Default setting: Video
You only need to make this setting if you connected this
recorder to another component using the AV2(INPUT 1/
DECODER) AV connector.
Initial Setup
Basic Input Colour System
Tuner Component Video Out
Video In/Out AV1 Out
Audio In AV2/L1 In
Audio Out NTSC on PAL TV
Language
Recording
Playback
The AV2(INPUT 1/DECODER) connector input can be
set to one of the following settings:
• Video – Sets the input signal type to composite
video.
• S-Video – Sets the input signal type to S-video.
• RGB – Sets the input signal type to RGB video (See
also Input Line System on page 108).
• Decoder – Use this setting if you are using a decoder
connected to the AV2(INPUT 1/DECODER) input.
(For scrambled channels, make sure that the manual
channel Decoder setting is set to On—see also
Manual CH Setting on page 110).
NTSC on PAL TV
• Default setting: On
Initial Setup
Basic Input Colour System
Tuner Component Video Out
Video In/Out AV1 Out
Audio In AV2/L1 In
Audio Out NTSC on PAL TV
Language
Recording
Playback
When set to On, NTSC discs (from the U.S., for example)
will play correctly on a PAL-only TV.
TV is already NTSC-compatible.
Depending on this setting and the Input Line System
setting (see Input Line System on page 108), the signal
format output when the recorder is stopped varies as
shown in the table below.
Note
1 Many recent PAL TVs are capable of correctly displaying NTSC pictures without the need for this setting. Check the manual that came with
your TV if you're not sure whether yours has this feature.
Video
S-Video
RGB
Decoder
On
Off
1
Change to Off if your
NTSC on PAL
Input Line System
TV
625 System Off
On
525 System Off
On

Audio In settings

NICAM Select
• Default setting: NICAM
Initial Setup
Basic NICAM Select
Tuner Tuner Level
Video In/Out External Audio
Audio In Bilingual Recording
Audio Out DV Input
Language Input Level (L1)
Recording Input Level (L2)
Playback Input Level (L3)
If you want to record the non-NICAM audio in a TV
broadcast, select Regular Audio, otherwise set to
NICAM. (When set to NICAM, you can still select
Regular Audio using the AUDIO button. See Changing
audio channels on page 33.)
Tuner Level
• Default setting: Normal
Initial Setup
Basic NICAM Select
Tuner Tuner Level
Video In/Out External Audio
Audio In Bilingual Recording
Audio Out DV Input
Language Input Level (L1)
Recording Input Level (L2)
Playback Input Level (L3)
Set to Compression if the audio level from the built-in
tuner is excessively high causing distortion.
Output when
stopped
PAL
PAL
NTSC
PAL–60
NICAM
Regular Audio
Normal
Compression
14
113
En