Pioneer DVR-920H Operating Instructions Manual page 80

08 Copying and back-up
Erase Section (Erase Sec)
Using this command you can delete a part of a Copy List
title, ideal for cutting out the commercial breaks in a
recording made from the TV.
1 Select 'Erase Sec' from the Copy List menu
options.
2 Use the
the title you want to erase a section from, then press
ENTER.
After selecting a title, a screen appears from which you
can mark the start and end points of the section to erase.
Erase Sec
HDD
Erase Sec
Back
3 Use the playback controls to find the start of the
section to erase, then (with 'From' highlighted) press
ENTER.
You can use all the usual playback controls, including
PLAY, PAUSE, scan (
( , ).
The bar at the bottom of the screen shows the current
play position in the title. After pressing ENTER, a marker
appears under the bar to show the start of the section.
4 In the same way, find the end of the section to
erase, then (with 'To' highlighted) press ENTER.
After pressing ENTER, another marker appears under the
bar to show the end of the section, with the section itself
marked in red.
Note
1 When Frame Accurate is set to Off (see Frame Accurate on page 118), the 'From' time and length of the erased section may differ by up to 0.5
seconds from that set.
80
En
1
(cursor left/right) buttons to select
16:00 Sun 11/08 Pr 5 LP
Title 2
Recording Time 0h32m55s
2-1 0.06.52.17
Play Pause
A B
From To
, ), and slow-motion
Play Pause
A B
From T
0.02.09.17
A
5 Select 'Yes' to confirm, or 'No' to cancel, then
press ENTER.
In the thumbnail viewer you can see a few seconds of
video either side of the marked section to see how the
edit will look.
6 Repeat steps 3 to 5 if you want to erase more
sections from the same title.
7 Select 'Back' (or press RETURN) to get back to the
main Copy List screen.