Audio In Settings - Pioneer PRV-9200 Operating Instructions Manual

The Initial Setup menu
Important
If you switch to Progressive when using a TV that is not
compatible with progressive-scan video, you will not be
able to see anything displayed on your TV. If this happens,
press and hold the + button on the front panel, then press
HDD. This will set the recorder's video output back to
Interlace.
Compatibility of this unit with progressive-scan TVs
Consumers should note that not all high-definition television sets
are fully compatible with this product and may cause artifacts to
be displayed in the picture. In case of 525 progressive scan
picture problems, it is recommended that the user switch the
connection to the 'standard definition' output (Interlace). If there
are questions regarding our TV set compatibility with this model,
please contact our customer service center.
This recorder is compatible with the following Pioneer displays
and monitors
Plasma display
• PDP-505HD, PDP-5030HD, PDP-4330HD, PDP-5040HD, PDP-
4340HD, Pro-1000HD, Pro-800HD, Pro-1000HDI, Pro-800HDI, Pro-
1110HD, Pro-910HD, PDP-4300, PDP-5031, PDP-502MX
Projection monitor receiver
• SD-533HD5, SD-643HD5, Pro-710HD, Pro-610HD, Pro-510HD,
Pro-720HD, Pro-620HD, Pro-520HD, Pro-730HD, Pro-630HD, Pro-
530HD, Pro-730HDI, Pro-530HDI, Pro-700HD, SD-641HD5, SD-
582HD5, SD-532HD5
NTSC on PAL TV
• Default setting: Off
Initial Setup
Basic Input Colour System
Tuner Component Video
Video In/Out NTSC on PAL TV
Audio In
Audio Out
Language
Recording
Playback
When set to On, NTSC discs (from the U.S., for example)
will play correctly on a PAL-only TV. Change to Off if your
TV is already NTSC-compatible.
Depending on this setting and the Input Line System
setting (see Input Line System on page 96), the signal
format output when the recorder is stopped varies as
shown in the table below.
NTSC on PAL
Input Line System
TV
525 System Off
On
625 System Off
On
On
Off
Output when
stopped
NTSC
PAL–60
PAL
PAL
Note
• Many recent PAL TVs are capable of correctly
displaying NTSC pictures without the need for this
setting. Check the manual that came with your TV if
you're not sure whether yours has this feature.

Audio In settings

External Audio
• Default setting: Stereo
Initial Setup
Basic External Audio
Tuner Dual Mono Recording
Video In/Out DV Input
Audio In Input Level (L1)
Audio Out Input Level (L2)
Language Input Level (L3)
Recording
Playback
If the external source is standard stereo, leave set to
Stereo. If each channel carries a separate soundtrack,
change to Dual Mono.
When the external audio is from the DV input, an audio
subcode channel within the DV audio tells the recorder
whether the audio is stereo or dual mono. This has
priority over the setting you make here.
Dual Mono Recording
• Default setting: L
Initial Setup
Basic External Audio
Tuner Dual Mono Recording
Video In/Out DV Input
Audio In Input Level (L1)
Audio Out Input Level (L2)
Language Input Level (L3)
Recording
Playback
When recording a dual mono source from an external
input in Video mode or VR mode set to FINE / MN 32, you
can choose to record either the L (left), or the R (right)
audio channel.
Note
• If you're recording in VR mode (except when set to
FINE / MN 32), both channels will be recorded and
you can switch them as you like on playback.
Stereo
Dual Mono
L
R
13
99
En