Table of Contents
Advertisement
ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
Before beginning
assembly,
carefully
read the
following
information
and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable
wrenches
• One rubber mallet
• One standard
screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Press a 45mm Square Inner Cap (14) into the top
of the Front Leg (2). Press two 50mm Round Outer
Caps (12) onto the ends of the Black Stabilizer
(29).
Attach the Black Stabilizer (29) to the Front Leg (2)
with two M10 x 63mm Carriage Bolts (18) and two
M10 Nylon Locknuts (19). Be sure the indents in
the Stabilizer and the name decal on the Front
Leg are in the positions shown. Do not tighten
the Locknuts yet.
2. Press four 5Omm Square Inner Caps (13) into the
tubes on the Frame (1). Make sure the slots on
the Caps are vertical to accommodate the
Screws (not shown) that will attach the Seat
(not shown) to the Frame.
Attach the Frame (1) to the Front Leg (2) with two
M1O x 63mm Bolts (30), two M10 Large Washers
(27), and two M10 Nylon Locknuts (19). Do not
tighten the Locknuts yet.
29
12
18
2
13
1
Slot
SIotj---_.
27
13
19
20
6
Advertisement
Table of Contents
