Table of Contents
Advertisement
3,
4,
Press two 50mm Round Outer Caps (12) onto the
ends of the Silver Stabilizer (4).
Attach the Silver Stabilizer (4) to the Rear Leg (3)
with two M10 x 63mm Carriage Bolts (18) and two
M10 Nylon Locknuts (19). Be sure the indents,
the waming decal, and the Rear Leg are orient-
ed as shown. Do not tighten the Locknuts yet.
Attach the Rear Leg (3) to the Frame (1) with two
M10 x 20mm Bolts (25) and two M10 Washers
(20),
Tighten the M10 Nylon Locknuts (19) used in
steps 1-3.
Press two 25mm Square Inner Caps (11) into a
Pad Tube (10).
Slide the Pad Tube (10) into the Front Leg (2).
Wet the ends of the Pad Tube with soapy water.
Slide two Foam Pads (9) onto the ends of the
Pad Tube.
Repeat this step with the other Pad Tube (10),
5.
Press a 25mm x 50mm Inner Cap (15) into the
Backrest Frame (5).
Attach the Pivot Bracket (6) to the Backrest
Frame (5) with two M!0 x 70mm Bolts (26) and
two M10 Nylon Locknuts (19). Do not tighten the
Locknuts yet.
Insert the Pivot Bracket (6) into the slot in the
Frame (1).
6,
Lubricate the M10 x 85mm Bolt (23) with grease,
Attach the Backrest Frame (5) to the Frame (1)
with the Bolt and an M10 Nylon Locknut (19). Do
not overtighten
the Locknut;
the Backrest
Frame must be able to pivot easily.
Attach the tether on the Locking Pin (21) to the
bottom of the Frame (1) with the M4 x 16mm
Screw (28).
Insert the Locking Pin (21) into the Frame (1) and
through an adjustment
hole in the Pivot Bracket
(6).
See the inset drawing. Attach an MI0 x 20mm
Bolt (25) and an M10 Nylon Locknut (19) to the
last hole in the Pivot Bracket (6),
Tighten the M10 Nylon Locknuts
(19) used in
step 5.
3
18
12
_4
7
Indents
Warning
Decal
19
19
3 20_
25
10
11
9
10
9
6
5
;
._e I
26f
5
19
19
23
Advertisement
Table of Contents
