Troy-Bilt SpringAssist TB25ET Operator's Manual page 15

2. Pull the old inner reel with existing line from the outer
spool
3. Insert the ends of the prewound inner reel line into
the outer spool eyelets (Fig. 25). Push the new inner
reel arrow side up, into the outer spool
4_
Fig. 25
Hold the inner reel in place and install the bump
knob, spring and foam sea[. Press down and turn the
bump knob clockwise. Grasp the ends and pull
firmly to release the line from the holding slots in the
inner reel (Fig. 23).
Releasing the inner Reel
[f the SpeedSpook _' does not release line correctly, pull
the ends of the line firmly from the spool (Fig. 23). [f this
does not the release line, follow the Cleaning the
5peedSpoof _ instructions.
CLEANING THE SPEEDSPOOU _
Cleaning the SpeedSpook _'may be necessary if:
Ajammed or excessive line must be removed
• The SpeedSpoo[ '_> becomes difficult to wind or does
not operate correctly when bumping the head on the
ground
1. Hold the outer spool and unscrew the bump knob
counterclockwise (Fig. 26).
2. Pull out the bump knob, spring and foam sea[
(Fig. 24).
4_
Remove any existing line from the inner reel before
cleaning. Remove any debris or grass from the knob,
spring, inner reel and foam sea[. Wash the inner reel
with warm soapy water (Fig. 27).
inner Reem
Fig. 27
Clean the shaft and the inner surface of the outer
spool To dean the shaft underneath the plunger,
press down on the plunger (Fig. 28). Remove any dirt
or debris from the shaft.
Fig. 28
NOTE: The inner reel must be totally dry before
reinstalling it into the outer spool Do not
lubricate the inner reel or outer spool assembly.
6. Mace the inner reel into the outer spool
7. Place the bump knob, spring and foam sea[ onto the
inner reel (Fig. 24).
8. Press the bump knob down and tighten clockwise.
9. Install new line as described in Line Installation for
the SpeedSpoof R:'.
Fig. 26
3. Pull the inner reel with existing line from the outer
spool
15