Troy-Bilt SpringAssist TB25ET Operator's Manual page 14

3_
4.
Pull oHdHineout of the HineHoading and HineHocking
holies (Fig. 19 and 20).
Insert a piece of trimming Hinestraight into one of the
two eyeHets in the outer spook Push it up through the
HineHoading hoHein the inner reeH(Fig. 19). Do not
bend the Hinewhen inserting it into the eyeHet.
TrimmBng Line
Eyemet
Line Loading Home
Fig. 19
Insert the line into the locking hole (Fig. 20). Do not
push the line more than a 1/2 inch (12.7 mm) into the
line locking hole. The line will form a small loop
(Fig. 20) when it is inserted correctly.
7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spook Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain (Fig. 22).
NOTE: Do not wind the inner reel before installing the
second piece of line.
Fig. 22
9_
If winding the line becomes difficult or if the line
jams, puii the ends of the line from the spool
(Fig. 23). Continue winding the inner reel
counterclockwise.
6_
/
Line Locking Hole
FWg. 20
PuH the Hinefrom the outer spool until the line is tight
against the inner reel (Fig. 21).
Fig. 23
_NSTALUNG A PRE-WOUND REEL
1. Turn the bump knob counterclockwise and remove
the bump knob, spring and foam seal (Fig. 24).
Spring
Fig. 21
14