Adding Channds M Tile Tv's Memory; Programming Channds Automatically - Toshiba DLP 46HM84 Owner's Manual

A L
Adding channels to the TV's memory
When you press Channel • or V, your TV will stop only on the
channels stored in the TV's channel memo U.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 25).
To program channels automatically:
1. Press MENU, and then press • or • until the SET UP menu
appears.
2. Press • or • until the TV/CABLE is highlighted, and then press
ENTER to display the pull-down menu.
3. Press • or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
SET UP
LANGUAGE
/.L_C;K SL [ ]]]]H :BL ]]]]Hi
ANT 1 / 2
ABLE
GH PROGRAM
ADD ! ERASE
O:SELECT _TE_:SET
4. Press ENTER.
5. Press • to select CH PROGRAM.
Note:
To tune the TV to a channel not pfogrammed
in the channel memory,, you must use the
Channel Number buttons on the remote
control.
©© ®
®®®
® ®®
MENU
•,v< 1,
ENTER
Channel AV
SET up
LANGUAGE ENG 19H
CLOCK SET _ _0_I_O
ANT 1 ! 2 _ _H_'_UUUUUUUUU_
TV / CABLE CAB_ _
ADD ! ERASE _ _B:::::::::::::::::::::
@:MOVE _ _:STAIqT
6. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please W_dt" appears.
7. When channel programming is complete, the message
"Completed" appears.
8. Press Channel • or • to view the programmed channels.
I 24
#01E22-25 46,52,62HM84 24
Black
(E) 46HM84, 52HM84, 62HM84
5/31/04,12:20 PM
r