Using The Advanced Picture Settings Features; Using Mpeg Noise Reduction - Toshiba DLP 56HM66 Operating Manual

t
HM66 ENbook Page 41 Thursday February 23. 2006 2:49 PM
Using theadvanced picturesettings
features
Using dynamic contrast
When dynamic contrast is set to On, the TV will detect
changes in the picture quality that affect the appearance of your
contrast settings and then automatically adjust the video.
When dynamic contrast is set to Off, the settings selected in the
Contrast field in Picture Settings will be used.
To select dynamic contrast preferences:
1
Press M_uand open tile Video menu.
2
Highlight Advanced Picture Settings and press @.
3 In the Dynamic Contrast field, select either On or Off.
4
NNNNNNNNNNNNNNNNNIIi! Reset iiiiiiiiiiiiiiii Done iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
To save the new settings,
highlight Done and press @. To
revert to the factory defaults, highlight Reset and press
Note: If you select the Movie picture mode and then set
the dynamic contrast to On, the picture mode will
automatically change to Preference in the Picture
Settings menu.
Using CableClear /DNR (digital noise
reduction)
The CableClear _?digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video cassette
or disc.
To change the CableClear/DNR settings:
1
2
3
Press _u and open the Video menu.
HigMight Advanced Picture Settings and press @.
In the CableClear/DNR
field, select your desired
setting.
Dynamic Contrast Or}
iiiiii ColorTemperature
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii Rese_ iiiiiiiiiiiiiiii Do_e iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i_!i
4
Notes:
• ffthe currentinputisANT 1, ANT2, VIDEO 1, or VIDEO
2, the menu will display the text "CableClear. " The
available selections are Off, Low, Middle, High, and
Auto.
• if the current input is ColorStream HD1, ColorStream
HD2, or HDMI, the menu wi// display the text DNR The
available selections are Off, Low, Middle, High and
Auto. Auto will react proportionally to the strength of
the noise. Low, Middle, and High will reduce the noise
in varying degrees, from lowest to highest, respectively.
To save the new settings, highlight Done and press @.
To revert to the factory defaults, highlight Reset and
press @.
Using MPEG noise reduction
The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression. Choices
for MPEG noise reduction are Off, Low, Middle, and Nigh. Off
is automatically selected when this feature is disabled ("grayed
out").
To select the MPEG noise reduction level:
1
Press _u and open the Video menu.
2
Highlight Advanced Picture Settings and press @.
Press • or • to highlight the MPEG Noise Reduction
field, and then press • or • to select either Off, Low,
Middle or High.
Dynamic Contrast On
4
Lamp Mode Low Power iiiiii
Game Mode Off
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_ iii i iiiiiii i iili iiiiiii i iiii ii i li iiii i
Reset Done
To save the new settings,
higMigl-a Done and press @.
To revert to the factory defaults, highlight Reset and
press @.
(con tin ued)
41
HM66 (E/F) Web 213:27(