How To Replace The Lamp Unit - Toshiba DLP 56HM66 Operating Manual

t
HM66 ENbook Page 48 Thursday Februar,t23. 2006 2:49 PM
How to replace the lamp unit
WARNING:RISK OF ELECTRIC
SHOCK!
TO REDUCE THE RISK OF ELECTRIC
SHOCK, NEVER REMOVE TV COVERS, EXCEPT AS
SPECIFIED HEREIN. REFER ALL SERVICING NOT
SPECIFIED IN THIS MANUAL TO QUALIFIED SERVICE
PERSONNEL. Failure to fellow this WARNING may result in
death or serious injury.
Required tools:
• Manual screwdrivers (Phillips and slotted)
• Soft, lint-free gloves
1
Turn off tile TV and unplug tile power cord.
WARNING:Eye damage may result from
directly viewing the light produced by
this lamp.
Always turn off the TV and unplug the power cord before
opening the lamp unit door.
2
STOP! Allow the lamp to cool for at least one (1) hour
before replacing it.
CAUTION:
HOT SURFACE!
Touching the lamp before it has cooled will result in
severe burns. ALLOW THE LAMP TO COOL FOR AT
LEAST ONE (1) HOUR BEFORE REPLACING IT.
On tile lamp unit door on tile back of the TV, loosen tile
screw by using manual screwdriver, and then remove the
lamp unit door.
TV back
Lamp unit door detail
screw
using manual
screwdriver
4
5
6
Using a manual Phillips screwdriver, loosen tile two
screws on tile lamp unit.
/
Lamp unit screws
WARNING:RISK OF ELECTRIC
SHOCK!
The lamp unit door is provided with an
interlock to reduce the risk of electric shock and excessive
ultraviolet radiation. Never defeat its purpose or attempt
to service without removing the lamp unit door
completely. Failure to follow this WARNING may result in
death or serious injury.
Grasp tile lamp unit handle and gently pull tile lamp unit
straight out of the TV. Set the old lamp unit aside
(_ "Disposing of the used lamp unit" on page 49).
NOTE:
Wear soft, lint-free gloves when
replacing the lamp unit.
Carefully insert the new lamp unit straight into the TV
until it is fully seated.
.... j
48
HM66 (E/F) Web 213:276