Replacing The Spark Plug; Storing Die Product; Transporting The Product - Toro 51938 Operator's Manual

Replacing the Spark Plug
See Figure 22
Model Nos.. 51930, 51932, & 51934 use a NGK
BPMR7A or Champion RCJ-6Y spark piugo
Model Nos.. 51930A, 51932A, 5t934A, 51936, 519.38,
& 51940 use a NGK CMR7A spark plug.. Use an exact
replacement and replace annually.
Follow these steps to replace the spark plug._
1. Remove the spark plug boot
2. Loosen the spark plug by turning it counterclockwise
with a socket.,
3. Remove the spark plug,
4, Hand thread the new spark plug, turning it dock-
wise.,
5. For Modal Nos.. 51930, 51932: Tighten with a
socket and torque to 170 in,.lb, minimum, I90 in lb,.
maximum,. Do not over tighten.
6. For Modal Nos. 51930A, 5193ZA, 51934A, 51936,
51938, & 51940: Tighten with a sodcet and torque
to 87 in.lb, minimum, I04 inolbm maximum_ Do not
over tighten.
&CAUTION:
I Be careful not to cross-thread the spark plug,. Cross-
Spark Plug Boot
Spark
Plug
Storing the Product
Storing the product differs depending on the amount of
time it will be in storage
Note: If die product includes another attachment, place
the storage cap on the end of the attadnnent shaft and
hang it up to store.
To Store the Product Short Term
Follow these steps to store the product short term
1. Clean ,allforeign material from the product,
2. Store the product in a well-ventilated place that is
inaccessible to &ildren,.
To Store the Product Long Term
if you do not intend to use the product for more than
one month,
follow
the storage procedures
bdow,,
Follow these steps to store die product long term,
1. Drain all of die fud from die tank into a container
approved for gasoline,
2, Run the engine tmtil it stops
3. Clean all foreign material from the product,
4. Store the product in a wall-ventilated place that is
inaccessible to dlildren,
Nolo: Keep the product away from corrosive agents
such as garden diemicals and de-icing salts,
Important:
Abide by al! federal and local regula-
tions for the safe storage and handling of gasoline,
Transporting the Product
Follow these steps to transport the product,,
1, Drain the furl mixture into a container that is
approved for use with gasoline,
2. Carry the product by die front handle,
3. Secure the product in your vehicle or on a trailer.,
Figure 22
Maintenance 23