Maintenance; Emissions Maintenance Schedule; Cleaning The Product; Servicing The Product - Toro 51938 Operator's Manual

Maintenance
Emissions Maintenance Schedule
Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-
road engine repair establishment or individual.
Fuel Tank Assembly (Indudes
Fuel Lines, Fuel Cap, and Fuel
Filter)
Air Filter
X
X
Spark Airester
Spark Plug
X
X
|L I ..... ,,I ,,I,UL .l|J, I LL,,I , I , , I
X
AWARNING:
When replacing pa_s other than engine or
emissions parts, Use only Toro replacement parts
Use of any or_herparts may create a hazard or cause
produc_ damage_
Cleaning the Product
I_ Stop the product before deaning
llt Clean the exterior of the product with a damp cloth._
Et Avoid using solvents when cleaning plastic parts..
Most plastics are susceptible to dasnage from various
t_3es of commercial solvents and may be damaged by
their use,
! Wipe or scrape the trimmer head and spool area
when they accumulate dirt or clippings,.
El Scrape debris away from air intake vents on both
sides of the motor housing°
ACAUTION:
Keeping air intake vents five of grass and debris
prevents motor ovethcating and possible faiture_
Note:
Depending on the type offiael used, the type
and amount droll used, and/or your operating con-
ditions, the exhaust port and mtLffier may become
blocked with carbon deposits. If you notice a power
loss with your gas powered tool, you may need to
remove d]ese deposits to restore performance We
highly recommended that only qualified service tedl-
nicians perform this sen,ice..
Replacing the Cutting Line
See t:'ig_tre18 and F,_re 1.9.
A WARNING: J
I Use oftine other than the proper monofilament |
Follow these steps to replace the cutting line_
1. Stop the trimmer
Servicing the Product
ml Che& and tighten a]! fksteners_ If any part is
damaged or lost, repair it or replace it
AWARNING:
Make sure the trimmer head stops rotating
Contact with a rotating trimmer head could cause
personal injury_
2. Remove the spark plug boot,. 5;_eFig_¢re 22
3.
Remove dxe retaining cap.,
4. Remove the empty spool
5. Clean the trimmer head thoroughly. Inspect the
trimmer head for any damaged or worn parts.
6. Hold the spool with the spring positioned upward
7. Insert the end of the new line into the hole in tile
upper threaded area of the spool
8. Wind the line around the spool as indicated by the
arrows on die top of the spool until the line readies
the edge of the spool. Do not wind the line beyond
the edge of the inner ring.
9.
Secure the line temporarily by pushing it into one of
the slotted tabs on the spool,,
10. Measure six inches of line from the slotted tab and
cut the line at that point_
20 Maintenance