Table of Contents
Advertisement
Assembly
Connecting
the Attachment to the Upper
Shaft
SeeFigure2,
Follow these steps to connect the attachment to the
upper sh_'t,
1.
Loosen the t_ob by turning it counterdockwise.
2.
Remove the end cap from the attachment shall
3.
Align the button on the attachment shaft with the
guide recess on die upper shaft,.
4.
Slide the attachment shaft into the upper shaft until
the attachment shaft clicks into place,.
Note: You may need to turn the attachment shaft to
properly align the two shafts.,
5.
Tighten the l_ob securdy by turning it clockwise
Guide
Recess
Upper Shaft
BuRon
__ment
Shaft
Knob
Figure 2
Removing the Attachment
from the Upper
Shaft
See Figure 2
Follow these steps to remove the attachment from the
upper shaft_
1_ Loosen the lmob by turning it counterdoclcwise.
2o Push the button while prying out tile attachment.
Attaching the Front Handle
See FigTwe3,
Follow these steps to attach the front handle
2_
Remove the slotted Torx
TM
screws to separate the
handle fi_om the handle support.
Press the handle onto the top of the upper shaft, no
less than 10 in, (25A cm) from the center of the trig-
ger handle, angling the handle
toward
the
trigger
handle_
3.
Place the handle along the upper shaft to a position
that allows for comfortable operation.
4.
Place the handle support on the bottom of the tube
on the opposite side of the front handle_
5.
Secure the handle with the slotted Torx
TM
screws
Slotted
Front
Torx
Handle
Screw
Handle
Support
Trigger
Handle
Barrier
Bar
(ModelNos=
51934 &
51940)
Figure 3
Attaching the Shoulder Strap
Model Nos. 51934 & 51940
See Figure 4
Follow these steps to attach the shoulder strap.
1.
Connect the latch on the strap to the hanger bracket.
2,
Adjust the strap to a comfortable position
Note: 1o quiddy release the product from the shoul-
der strap, sharply puli the quick rdease tab
Stra
Quick
Release
Tab
Latch
Hanger
Bracket
Figure 4
12
Assembly
Hide quick links:
Advertisement
Table of Contents
