Table of Contents
Advertisement
To select a Type
Put the digital surround processor into standby by pressing
Off (front panel or remote).
Hold down the A key on the front
panel until the display shows:
Hold down the A key for three
more seconds until the display shows:
It will then show the current Type
setting; for example:
Press
or on the front panel to select the Type.
For example, if you have two analogue
speakers select the display:
Wait for a few seconds, while the
display shows:
Press the Off key on the front panel.
The display shows:
To set up the 568.2 for use with a 562
or 562V Multimedia Controller
While in Type, select 562 Mode as follows:
Type in... 3
Type,wait...
Type 5.1 AAA
In 562 Mode all the digital and analogue sources use CD/D1 and
TV/A1 respectively:
Source
Type 2.0 A__
CD, Tape 2, CDR, Cable, DVD, and LD
Radio, LP, TV, Tape 1, VCR 1, and VCR 2
Typing, wait
If a multi-channel input card is present, the DVD source is
assigned to the M1 input.
For information about connecting up the 568.2 see To connect
to a 562 or 562V Multimedia Controller, page 65.
Exiting Type
Press the Source key on the front
panel; the display shows:
Press the Source key again to turn off 562 Mode. While 562
Mode is on the Dolby indicator is illuminated.
562 Mode on
Input
CD/D1
TV/A1
69
Advertisement
Table of Contents
