Fisher-Price DIRECT LINK PRIVACY 71592 User Manual page 11

PROBLEMS AND SOLUTIONS
PROBLEM
Weak reception Out of range or insufficient signal
AC adaptor cord(s) not fully extended
Improper antenna position
Receiver variable lights Weak or dead battery in receiver
display does not light
Interference Signal interference due to another
(buzzing, static, etc.) nursery monitor or cordless
and signal indicator on telephone, etc.
receiver is ON
Channel switches not on same
setting (channel)
Interference Signal interference due to other
(buzzing, static, etc.) nursery monitors or cordless
and signal indicator on telephones, etc.
receiver is OFF
Channel switches not on same
setting (channel)
Receiver power is ON but transmitter
power is OFF
Code switches in receiver and
transmitter do not match
Interference Signal interference due to another
(garbled voices) and Fisher-Price
signal indicator on
receiver is ON
Feedback Receiver is too close to the transmitter
(squealing or whistling)
Volume is set too high
All five bars on the Receiver power is ON but
receiver variable lights transmitter power is OFF
display light
Out of range or insufficient signal
Channel switches not on same
setting (channel)
AC adaptor not properly connected
to transmitter
PROBABLE CAUSE
Direct Link Privacy Monitor
® ™
SOLUTION
Test reception by moving the transmitter and/or receiver to different locations
throughout the house. Relocate the transmitter and/or receiver.
Fully extend AC adaptor cord(s).
Make sure antennas are pointing upward.
Replace the battery in the receiver with a fresh 9V alkaline battery or
use the AC adaptor.
Change channel switch on both transmitter and receiver to the other channel.
Set channel switch on transmitter and receiver to the same channel.
Change channel switch on both transmitter and receiver to the to the
other channel.
Identify and eliminate source of interference. Do not use more than one
transmitter at the same time in the same house.
Set channel switch on transmitter and receiver to the same channel.
Make sure the transmitter is ON. The power indicator should be lit.
Reset code switches in receiver and transmitter so that they match.
Make sure transmitter power is ON.
Change channel switch on both transmitter and receiver to the other channel.
We recommend "Checking Privacy" periodically. See page 6.
Move receiver further away from transmitter.
Lower volume on the receiver.
Turn the transmitter power ON.
Move the receiver closer to the transmitter.
Set channel switches on transmitter and receiver to the same channel.
Check AC adaptor jack-to-socket and plug-to-outlet connections.
11