NordicTrack A2050 NTL10850 User Manual page 9

Settheconsob assembly o ntheUpright B ase(85). M ake
surethatnowiresarepinched. F inger t ighten a Consob
Bolt(72)witha StarWasher ( 67)intothelower hob in
eachsideoftheUpright B ase(onlyonesideis shown).
Next, f ingertighten a Short C onsobBolt(112)witha Star
Washer ( 67)intotheupper hob ineachsideofthe
Upright B ase(85)(onlyonesideis shown). B ecarefuJ
not to droptheShort ConsoJe Bolt into the Upright
Base.Firmly tighten allfourConsobBolts.
Press an Upright Endcap (71),withtheendindicated by
thearrow first,intoeachsideoftheUpright B ase(85)
(onlyonesideis shown), U sea rubber m allet i f necessary,
85---- I
112 ....
67-- i
72-
Console
Assembly
9. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin.
Press the Latch insert (77) into the left side of the Upright
Base (85) as shown. Use a rubber mallet if necessary.
insert the pin into the Latch insert. Tighten the knob back
onto the pin.
77
Spring
Collar
lO.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the
floor or carpet from damage, place a mat under the treadmill.
if you purchase the optional chest puJse sensor (see page 23), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated 3/4" Screw (7) and the Access Door (95)
from the left side of the Console Back (96).
2, Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96), Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two ino
cluded small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (95) with the 3/4" Screw (7). The other
wires included with the receiver may be discarded.
//
96 /
W ire
/
7 A
Small
Screws
Small
Cylinder