Table of Contents
Advertisement
Locate the Reed Switch (22) and the Magnet (18) on
the Heftside of the Pulley (17), Turn the Pulley until the
Magnet is aligned with the Reed Switch, Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". if necessary, ioosen the Screw
(23), move the Reed Switch sHghtiy, and then retighten
the Screw, Reattach the Hood (33), making sure that
the Screws (7) are inserted into the same hobs from
which they were removed, Run the treadmHi for a few
minutes to check for a correct speed reading,
Top
View
U
PROBLEM:
The walking
belt slows when walked on
SOLUTION:
a, Use oniy a singie-outiet surge suppressor that meets ali of the specifications described on page 10,
b,
if the waiMng bent is overtightened, treadmili perfor-
mance may decrease and the waiking bentmay be-
come damaged, Remove the key and UNPLUG THE
POWER CORD, Using the allen wrench, turn both
rear roller adjustment boits counterciockwise,
1/4 of a
turn, When the waiking bent is properiy tightened, you
shouid be abie to Hilteach side of the waiking bent 3 to
4 inches off the waiking piatform, Be carefui to keep
the waiking bentcentered, Hug in the power cord, in-
sert the key, and run the treadmiiH for a few minutes,
Repeat untii the waiking bent is properiy tightened,
Rear Roller Adjustment Boits
c, if the walking belt still slows when walked on, please call our Customer Service Department, tolP
free,
PROBLEM:
The walking
belt is off-center
or slips when walked on
SOLUTION:
a, if the walking belt is off-center, remove the key and
UNPLUG THE POWER CORD, If the waJking belt
has shifted to the teft, use the allen wrench to turn
the Heftrear roller boit ciockwise 1/2 of a turn; if the
waJking belt has shifted to the right, turn the Heft
rear roller boit counterciockwise
1/2 of a turn, Be
careful not to overtighten the walking belt, Hug in the
power cord, insert the key, and run the treadmill for a
few minutes, Repeat until the walking belt is centered,
b,
if the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD, Using
the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn, When the walking belt is correctly tight°
ened, you should be able to lift each side of the walk-
ing belt 8 to 4 inches off the walking platform, Be
careful to keep the walking belt centered, Hug in the
power cord, insert the key, and carefully walk on the
treadmill for a few minutes, Repeat until the walking
belt is properly tightened,
27
Hide quick links:
Advertisement
Table of Contents
