Table of Contents
Advertisement
5_
6_
Figure 4=11
Install the bagger cover onto the bag support
assembly,
as
seen in Fig. 4-12. The plastic cover goes inside of the two
mounting
tabs.
Figure 4=12
Slide the hinge pin into the hole located
on the mounting
tab, as in Fig. 4-13. Use the cut-out
window
(See inset in
Fig. 4-13) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop.
At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Fig. 4-14.
Figure 4=13
n'_
Figure 4=14
7.
Open Hood by pushing
in on the rear, right-side
tab with
your right hand, as seen in 1 of Fig. 4-15, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
Figure 4=15
SECTION
4 --
ASSEMBLY&
INSTALLATION
11
Advertisement
Table of Contents
