MTD 31A-020-900 Operator's Manual page 13

CAUSE
Unit is unplugged
Trigger lock button or trigger were improperly actuated
Overload protection switch has popped out
ACTION
Check cord to make sure it is plugged into an electrical
outlet
Press in trigger lock button, hold it, and press in trigger
Push it in and follow the starting instructions
CAUSE
Belt is damaged
ACTION
Replace the belt, according to inspecting/Replacing the
driver belt
CAUSE
Scraper is worn
ACTION
Replace the scraper
If further assistance is required, contact your authorized service dealer
Motor type .................................................................... A. C, 120 Volts Electric
Amperage ..................................................................... 7.5 Amps
clearing Width ................................................................. 12.5" (318mm)
Intake Height .................................................................. 6" (152mm)
Weight ....................................................................... 15 tbs
12