Magnavox ZV457MG9A Owner's Manual page 97

VCR FUIC"I'IOI5 ..............
This feature allows you to set the recording length simply
by pressing [REC] on the remote control.
Press [VCR] first.
1)Insert a recordable tape with an erase-protection
tab intact.
2) Select the recording mode using [REC MODE].
(Refer to "Note for DVD to VCR duplication" on page 52
and "Recording" on page 94.)
3) Select stereo or SAP. Refer to page 35.
4) Select the desired channel to record using
]CHANNEL -_ / m] or [the Number buttons].
5) Press [REC] to begin the one-touch timer recording.
You can select a fixed recording time by pressing
[REC] repeatedly.
When the one-touch timer recording is finished, the
unit will turn to the standby mode automatically.
To change the recording length during the one-
touch timer recording:
Press [REC] repeatedly until the desired length appear.
To cancel the one-touch timer recording within the
specified time:
Press [STOP II].
|
An index mark will be assigned at the beginning of each
recording you make. You may skip to a specific marked
point by following the steps below.
Press [VCR] first.
1) Press [SEARCH] so that "INDEX SEARCH" menu
appears.
2) Using [the Number buttons], enter the number of
recordings you wish to skip within 30 seconds.
INDEX SEARCH
03
3) Press [_1_1], [1_1_]to start index search.
If you want to go in the forward direction, press [1_1_].
If you want to go in the reverse direction, press [_1_1].
After index search, the VCR will play back the cassette
tape automatically.
CURRENT PROGRAM
Beginning | End
of tape _ of tape
02 01 01 02 03
f
INDEX MARK
©
D
i...................................
©
&
i];
i S;I
P_Y
E
IQ
EN 95