Magnavox ZV457MG9A Owner's Manual page 101

"IIIIIi'IOUBL MOOTING .............
The disc tray does not open when you • It may take a few seconds for the disc tray to open after you have
press [OPEN/CLOSE_]. recorded or edited a disc. This is because the unit is adding disc data to
the disc.
"Repairing" appears on the TV screen.
In a case you intend to cancel the
repairing process.
1
Do you want to cancel a repairing
process? When selecting "Yes",
the disc may not be usab!e_
Yes
No
• If there is a power failure or unplugging during recording, finalizing,
formatting or editing (even after "Repairing" disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
• If you intend to cancel the repairing process, press [__OPEN/CLOSE]
on the front panel, then select "Yes" and press [OK]. After that, press
[OPEN/CLOSE _] to take out the disc. The disc canceled during the
repairing process MAY NOT work.
Picture noise appears. • Head cleaning for VCR may be necessary. Refer to "Auto head cleaning"
(page 4).
• Adjust tracking control for better picture by pressing [CHANNEL +/--]
while you are playing back a cassette tape.
The cassette tape does not play back. • No cassette tape is inserted.
Recording does not start afteryou press • Make sure the cassette tape has an erase-protection tab when you
[REC]. record to a cassette tape. If needed, cover the hole with cellophane
tape.
The remote control does not function. • Check if a cassette tape is in this unit.
The motor rotates even when • The motor may rotate for the duration of approximately 5 minutes for
playback / recording is stopped, efficient operation. This is not a malfunction.
©
D
©
IQ
7,/_i
II
EN 99