Turning Onthetv/Vcr - Philips CCB193AT Owner's Manual

8 Turning OntheTV/VCR
°.. °o. o, oo, °°oo oo o °o °° °°° °, ° ,°o °, ° o ° ° °o
• _*o o** o_* *w 0. _ io* .otoeoe *ll _o o*m.** _t_ee* *.lJ_* .t* *0 • to • * • •
Before you turn on the'rV/VCR, make sure batteries are in the
remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
I
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
> ENGLISH ON
ESPANOL
SELECT &V OR
ESS MENU TO CONTINU
2
Press the PLAY/A button or the STOP/v button to select
F-_glish or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear.
TO TVCR
THEN PRESS!1_
END PRESSEXIT
4
Press the F.FWD/_ button to begin automatic channel
setup, The TV/VCR will memorize all available channels.When
channels are set, CHANNELS ARE SETwill appear on the screen
briefly.Then the TV/VCR will go to the lowest channel pro-
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ,.. messagewill appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on the
TV/VCR, then press the EFWD/I_ button again.You may need to
follow the steps on page 10 instead.)
5
Use the CH(annel) _/_ button or the Number buttons
on the remote control to select aTV/VCR channel. Use
the VOL(ume) _/_ button to adjust the sound.
Helpful Hints
If you do not see any on-screen dis-
plays when you turn on the TVIVCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine-10 to select a language and
set up channels.
To skip step 2, press the MENU
button. All on-screen displays will be
in English.To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS NOT
SET will appear on the screen
briefly.
You cannot set up channels if you
are using a Cable Box.
Line Input mode will always be
stored in the TV/VCR's memory as
channel 00.When you select chan-
nel 00,A/V IN will appear on the
screen briefly. Press the CH(annel)
_/'_7 button or the Number but-
tons to select another channel.