Philips CCB193AT Owner's Manual page 44

To change the access code, follow these steps.
I
:_SMARTLOCK
REVIE_V
EXIT
PRIM SETUP
: VCR PROGRAM
VCR SETUP
Press the MENU button.
iPRESS_
2
Press the PLAY/A button or the STOP/Y button to select i
SMARTLOCK.Then, press the F.FWD/_" button.
_ SMARTLOCK _ 5
Enter Your Access Code
3
Use the Number buttons to enter your old access code.
The default code is 071 I. If you have never set up your personal
access code, use 071 I now.
After you enter the code, the SMARTLOCK menu will appear.
Enter Your Access Code
4
Press the PLAYtA button or the STOPIV button to select
CHANGE CODE,Then, press the EFWD_ button.
BLOCK
• CHANGE CODE
SELECT AV CHOOSE I_
END PRESS EXIT
5
Use the Number buttons to enter your desired access code
in the New Code space.Then, enter the same code in the
Confirm Code space.
Your new access code should be recorded.You will return to the
SMARTLOCK menu.
nt'rm Code
6
Press the STATUS/EXIT button.
24
6
i
In order to protect the privacy of
the access code, an X will appear
on the screen instead of the num-
ber you enter.
• If a "Wrong Code..." message
appears on the screen after you
complete step 5, you entered the
wrong numbers in the Confirm Code
space. Repeat the steps on this
page.
Youcannot use the default code
after you set up your personal
access code.
If a power failure occurs, the default
code, 071 I, will be the active access
code again.
If you connect the power cord to an
AC outlet that is controlled by a wall
switch, your personal access code
will be erased every time you turn
off the power at the wall switch.The
default code will be the active code
again.