Turning On The Tv/Vcr - Philips CCZ190AT99 Owner's Manual

CCZ190comb.QX33 4/5/99 9:51 PM

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure there are batteries in
the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish on-screen displays.
3
Press the MENU button. The screen shown below will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the FF/SEARCH B button to begin automatic chan-
nel setup. The TV/VCR will memorize all available channels.
When channels are set, CHANNELS ARE SET will appear on-
screen briefly. Then the TV/VCR will go to the lowest channel
programmed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on-
screen. Connect an antenna or cable to the TV/VCR, then try
again. You may need to follow the steps on page 10 instead.)
5
Use the CHANNEL o/p buttons or the Number buttons
on the remote control to select a TV/VCR channel. Use
the VOLUME o/p buttons to adjust the sound.
Page 8
3
1
POWER MENU STATUS/EXIT CLEAR
1 2 3
MEMORY
4 5 6
CHANNEL
7 8 9
5
0 +100
ALT.CH
SLEEP
VOLUME MUTE
SPEED
2
REW/SEARCH PLAY/ FF/SEARCH
REC/OTR STOP/ PAUSE/STILL
Helpful Hints
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 10 to select a language and
set up channels.
• To skip step 2, press the MENU
button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS
NOT SET will appear on-screen
briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode will always be
stored in the TV/VCR's memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on-
screen briefly. Press the CHANNEL
o/p buttons or Number buttons to
select another channel.
4