Symbols Used In This Manual; Supplied Accessories; Attaching The Stand - Magnavox 42MD459B User Manual

[] Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
IkV| dlJ _ [q li [e] _ l,,
Analog TV operation
: Digital TV operation
• If neither symbol appears under the function heading,
operation is applicable to both.
:| II.ll :__*Y| d IJ _ [q li [e] _ I.
: Playback of BD-video
: Playback of DVD-video
: Playback of audio CD
• If none of symbol appears under the function heading,
operation is applicable to all.
Supplied Accessories
user manual quick start guide main remote
(1EMN24659) (1EM N24663) control
(NF034UD)
simple remote registration card screw kit for
control (NH 100UD) (1EMN24699) attaching the stand
(1 ESA20607)
batteries
(AA x 2)
batteries cable AC power cord
management tie (WAV0162LW001) or
(AAA x 2) (1 EM428657) (WAV0162LTE03)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
Attaching the Stand
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper
direction.
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by above "(2_"screw
holes. After the screws are removed pull the stand up toward
the rear of the unit. Be careful not to drop the stand when you
remove it.
2 Insert the neck under the bottom
of the main unit to the stand%hole
(shown by arrow (_)).
3 Drive Phillips pan screws in the 4
threaded holes at the bottom of the
stand until they are tight.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
EN