Magnavox 42MD459B User Manual page 17

[] Initial Setup
Thissection will guideyouthroughthe unit'sinitial settingwhichincludes
selecting a language for youron-screen menuandautoprogram, w hich
automatically scans andmemorizes viewablechannels.
Beforeyou begin:
Make sure theunitisconnected toantenna orcable.
After making all the necessary connections,
press [POWER O] to turn on the unit.
POWER
2
• This operation may take a few moments.
Use [Cursor Air] to select the on-screen language
from the choices on the right side of the -IV screen.
(English / Espa_ol/Franc_ais)
or
• "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [OK].
3 Use [Cursor Air] to select "Antenna" for -IV channels
or "Cable" for CATV channels, then press [OK].
or
• "Autoprogram"will begin.
_+ Use [Cursor ,/I_] to select the desired location setting,
then press [OK].
or _+
• Select "Retail", the unit will be set up with predefined
setting for retail displays. In this setting, the power
consumption may possibly exceed the limited
requirement of the ENERGY STAR® qualification.
• Select "Home", the unit is set to maximize the energy
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality
according to your preference.
• When the initial setup is completed, the lowest
memorized channel with the confirmation message
of the location setting will be displayed on the TV
screen.
Note:
• Ifyou connect the cable system directly, contact the CATV
installer.
• If you press [POWER O] or [MENU / EXIT] during
autoprogram, this setting will be canceled.
• The initial autoprogram function can be executed for either
"Antenna" or "Cable" only once. When you change the
connection (Antenna / Cable), set autoprogram again.
(Referto page 22.)
• If there is no signal input from the antenna terminal and
no operation for several seconds after you turn on the unit,
"Helpful Hints" appears. Follow the instructions listed on the
TV screen.
• Youmust set "Home" in step 4. Otherwise, the settings
of picture and sound quality you adjusted will not be
memorized after you turn off the unit.
+ ......................................
After on initial setup is completed...
• If you want to scan the channels automatically again,
refer to "Autoprogram" on page 22.
• You can add the desired channels unmemorized by
"Autoprogram". Refer to "Add Channels" on page 23.
• If you want to change to another language, refer to
"Language Selection" on page 24.
• If you want to change the location setting, refer to
"Location" on page 35.
EN