Advertisement
lease make these simple
checks
before calling for
ser,,ice.
Theses tips can save you
time and money since charges for
TV installation
and adjustment
of
customer
controls
are not
covered
under your warranty.
No Power
No Picture
No Sound
Remote
Does Not
Work
TV Displays Wrong
Channel
or No
Channels
Above 13
CAUTION: A video source (such as a video game, Compact Disc Interactive - CDI, or
TV information channel) which shows a constant non-moving pattern on the TV screen,
can cause picture tube damage. When your TV is continuously used with such a source
( the pattern of the non-moving portion of the game (CDI, etc.) could leave an image
I permanently on the picture tube. When not in use, turn the video source OFF.
Regularly alternate the use of such video sources with normal TV viewing.
E"Check the TV power cord. Unplug the "IV', wait I 0 seconds, then reinsert plug into
j
i outlet and push POWER button again.
I
_,-Check to be sure outlet is not on a wall switch.
_- Check antenna connections.
Are the properly secured to the TV's ANT/CABLE pluo ? |
Check the CABLE/YES
NO control for correct position.
!
, Check INPUT contro! for correct position. VCR-AUX or S.-VIDEO position without a
i signal source will result in a blank screen.
1- Check the VOLUME buttons.
l- Check the MUTE button on the remote control.
'_-Check the SPEAKER on-screen control. OFF position will eliminate sound at the set.
i. If attempting auxiliary equipment hook-ups, check audio jack connections.
J-Check TV-VCR-CBL "'System" buttons on the remote.
Press the remote's TV System
button to send commands to the TV.
• Check batteries. Replace with AA Heavy Duty (Zinc Chloride) or Alkaline batteries
j if necessary.
i" Clean the remote and the remote sensor window on the TV.
i, Check the "Iv power cord. Unplug the "IV, wait 10 seconds, then reinsert plug into
i outlet and push POWER button again.
i" Check to be sure "IV outlet is not on a wall switch.
i.Repeat channel selection.
!- Add desired channel numbers (CHANNEL control) into TV memory.
t
1" Check CABLE/ YES NO control for correct position.
•This TV is equipped with protective circuitry that shuts the TV off in case of moderate
power surges. Should this occur turn the TV back on by pressing the POWER button
once or twice, or unplug (wait !0 seconds) and then replug the power cord at the AC
outlet. This feature is NOT designed to prevent damage due to high power surges such
as those caused by lightning, which is not covered by your warranty.
Cleanin_ and Care
• To avoid possible shock hazard be sure the TV is unplugged from the electrical outlet before cleaning.
• When cleaning the TV s_een take care not to scratch or damage the screen surface (avoid wearing jewelry or using
anything abrasive).
Wipe the front screen with a clean cloth dampened with water. Use even, easy, vertical strokes when
cleaning.
• Gently wipe the cabinet surfaces with a clean cloth or sponge dampened in a solution of cool clear water. Use a clean dry,
cloth to dr), the wiped surfaces.
• Occasionally vacuum the ventilation holes or slots in the cabinet back.
• Never use thinners, insecticide sprays, or other chemicals on or near the cabinet, as they might cause permanent marring
of the cabinet finish.
Advertisement
