Advertisement
m
our TV remote can be set to
ork your VCR or Cable
Converter by what is called the
SEARCH method.
lf the "REMOTE CODE" number
method shown in the previous
section did not set your remote to
work your VCR or Converter. then
follow the easy steps listed below.
Please read through steps 1-4
before be_nning.
cag f
-,,,_@ Press the POWER button on
the VCR or Converter to turn the
unit ON.
Stand at least six
away
feet
from the front of the VCR or
Converter.
Point the remote toward the unit.
HOLD DOWN the SURF and
the desired System (VCR or
CBL-Converter)
buttons at the
same time. KEEP HOLDING
BUTTONS DOWN.
_,,,_
Watch the Channel Indicator
on the unit.
Channel Numbers will SCAN UP
when the unit has been identified.
This may take up to two minutes.
Release the SURF and System
(VCR or CBL) buttons as soon
.aschannel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Converter.
_//'
Remember,
minute or
a
N two can seem veD' long, but
the code should be located within
two minutes.
Don't let the VCR sczn up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps 1-
,1. Should a channel change still
not occur, the remote will not work
with the desired unit.
CABLE
CONVERTER
1
T
Six Feet
(minimum)
26
Advertisement
