Figure - Grizzly G0732 Owner's Manual

Dust Collection
DO NOT operate this table saw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Components and Hardware Needed:
Recommended CFM at Dust Port: 250 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.

Figure 31

2.
Note: A tight fit is necessary for proper
performance.
Figure 31.
Power Connection
Connecting Power
1.
Qty
2.
Figure 32. Connecting power.
Disconnecting Power
1.
2.
Figure 33. Disconnecting power.
OFF
OFF