Throttle Linkage And Ignition Leads - Shindaiwa C282 Owner's/Operator's Manual

Assembly (continued)
4. Handlebar Adjustments:
a. Loosen 2 lower cap retaining screws (A) to adjust handlebar location on
outer drive shaft tube.
b. Loosen 4 handlebar clamp screws to adjust handgrip position.
Access handlebar clamp screws through 4 holes (J) in bottom of handlebar
mounting bracket.
c. Tighten all clamp and retaining screws securely after making final
adjustments.

Throttle Linkage and Ignition Leads

1. Loosen the air cleaner cover knob and remove the air cleaner cover.
2. Thread throttle cable adjuster (A) into throttle cable bracket (B), and install wire
end into large carburetor swivel hole (C). Check throttle for freedom of move-
ment and that wide open throttle/low idle extremes are adjusted properly. Turn
the cable adjuster in or out to make adjustments. After adjusting, hold the cable
adjuster (A), and tighten the cable adjuster nut (D) against the cable bracket (B)
to lock the setting.
3. Connect 2 ignition stop leads from throttle cable tubing to ignition leads on
engine (E) and grounding screw (F).
4. Reinstall the air cleaner cover.
5. Secure plastic flex tubing to outer driveshaft tube using plastic clamps (I)
provided.
J
E
A
E
J
E
B
A
D
F
I
I
J
E
J
E
C
7