Throttle Linkage And Ignition Leads; Blade Installation; Install Metal Shield - Shindaiwa X7502825900 Owner's/Operator's Manual

Shindaiwa brushcutter owner's manual
Table of Contents

Advertisement

Assembly (continued)
Throttle Linkage and Ignition
Leads
Adjust throttle trigger free play
The throttle trigger free play should
be approximately 4 - 6 mm (3/16"
- 1/4"). Make sure that the throttle
lever operates smoothly without
binding.
1.
Loosen the air cleaner cover
knob(s) and remove the air cleaner
cover.
2.
Place throttle linkage (A) through
adjustment fixture (B) and install
wire end into large carburetor throt-
tle swivel hole (C). Check throttle for
freedom of movement and that wide
open throttle / low idle extremes are
adjusted properly.

Blade Installation

WARNING
You must install the U-Handle and all Blade Conversion parts shown in the following instructions before operating this
unit with a metal blade, otherwise serious injury may result.
Model C254includes U-Handle, and necessary blade conversion parts. Blades are not provided with trimmer/brushcutters
and must be selected for type of cutting being performed.

Install Metal Shield

Tools Required: 8 x 10 mm Open-end Wrench, Screwdriver, 17x19 mm Wrench,
4 mm Hex Wrench
Parts Required: Metal Shield, Shield Bracket,
3 - 5 x 10 mm screws w/captivated flat and lock-
washer, (metal shield to gear housing).
2 - 5 x 8 mm screws, 2 - 5 mm nuts, 2 - 5 mm lock-
washers, (bracket to shield).
2 - 5 mm nuts, 2 - 5 mm lockwashers
(bracket to gear housing)
1.
If installed remove nylon line head, adapter plate, shield plate, and plastic
shield.
a. Align locking hole in adapter plate with notch in edge of gear housing and
insert locking tool (A).
b. Remove line head (B) by turning it clockwise until head is completely off of
shaft.
c. Remove locking tool.
8
4-6 mm
(3/16"-1/4")
Throttle Free Play
Throttle trigger free play
3.
Turn the cable adjuster in or out as
required to obtain proper free play 4
- 6 mm (3/16 - 1/4 in.).
4.
Connect 2 ignition stop leads from
throttle cable tubing to 2 ignition
leads on engine.
5.
Reinstall the air cleaner cover.
NOTE:
Cable
A
B
Adjuster
Remove air cleaner cover
C
C
A
B

Advertisement

Table of Contents
loading

This manual is also suitable for:

C254

Table of Contents