Remote Control Software; Remote Control Software Windows Installation - M-Audio Portman 4x4 Manual

Hide thumbs Also See for Portman 4x4:
Table of Contents

Advertisement

6. Select the Midiman PORTMAN 4x4/S driver from the list box
and click on "OK".
7. Click on "Finish". The rest of the installation is the same as
from Step 10 of the "Windows 3.1 Driver Installation".
IMPORTANT: With Windows 95 make sure to click on the
"Enable Driver" box. If you fail to do this the PORTMAN 4x4/S
driver will not be enabled.
ATTENTION: If you experience a problem with the Portman
4x4/s not initializing, there's a setting change you'll need to
make under the advanced settings of the driver. This is due to
the speed of the system and parallel port. Go to the "Control
Panel," double click on "Multimedia," click on the "Advanced"
tab, double click on "Midi Devices and Instruments." There
you'll see the outputs for the Portman 4x4/S, highlight output
number one, click on "Properties" and then click on settings.
You will see settings for the driver, click on the advanced but-
ton. Adjust the "Extra Pulse Width" to 75 by incrementing up.
Click on OK to get out and then re-boot Windows for this to
take effect. If you still have problems or it's not initializing then
adjust the Extra Pulse Width by 25. We have seen some systems
requiring settings up to 200.

Remote Control Software

Included with your PORTMAN 4x4/S is Windows Remote
Control software that enables you to configure and control the
PORTMAN 4x4/S SMPTE functions, and set up patchbay pro-
grams from your PC. The software enables you to set user bits,
frame format, flywheel and write start time (offset), as well as
start and stop SMPTE writing. Different Remote Control software
settings may be saved to disk as "configurations" and reloaded at
a later time.

Remote Control Software Windows Installation

To install the PORTMAN 4x4/S Remote Control application into
Windows, make sure you are in the Windows Program Manager
and insert the PORTMAN 4x4/S Remote Control diskette into
your disk drive. Next, under the "File" menu select "Run...".
When prompted to enter a command line type either
22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents