Front And Back Panel; Front Panel; Dip Switch Settings - M-Audio Portman 4x4 Manual

Front and Back Panel

Front Panel

l
P
ATCH
I
NTER
I 1
N
1. 2.
1. Interface indicator LED - This LED, when lit, indicates that the
PORTMAN 4x4/S is operating in MIDI Interface mode.
2. Patchbay indicator LED - This LED, when lit, indicates that the
PORTMAN 4x4/S is operating in Patchbay mode.
3. MIDI Connectors - These connectors are for MIDI In 1, Out 1, In 2,
and Out 2 respectively.
4. MIDI Out LEDs - These LEDs indicate MIDI Out activity on the
indicated ports (1 through 4).
5. MIDI In LEDs - These LEDs indicate MIDI In activity on the indicat-
ed ports (1 through 4).
6. Reset switch - This switch, when pushed, will send Note Off and
Controller reset messages on all MIDI ports and channels. It then
returns the PORTMAN 4x4/S to its previous mode.
7. DIP switches - The right most two dip switches set the SMPTE Write
Format. The left most switch enables and disables SMPTE
Regeneration. Please note: the SMPTE format set on the Format DIP
switches may be overridden by using the PORTMAN 4x4/S Remote
Control software. The SMPTE Write format, as set by the two right
Format dip switches, have the following settings:
M
IDI
(insert Front Panel fig 1. here)
O 1 I 2 O 2
UT N UT
3. 4.
put dip switch Write format figure here
O
FF
24 Frames
O
N
O
FF
30 Drop
O
N
Portman 4x4/S
PC MIDI INTERFACE/SMPTE SYNC
M O
IDI UT
R
ESET
1 2 3 4
O
FF
M I
O
IDI N N
5. 6. 7.
O
FF
O
N
O
FF
O
N
8
R
EAD
W
RITE
R
EGEN
W
RITE
8. 9. 10.
25 Frames
30 Non-drop