Drivers; Windows 3.1 And 3.11 Driver Installation - M-Audio Portman 4x4 Manual

have looped from SMPTE In to SMPTE Out is good.

Drivers

MIDI application software communicates with the PORTMAN
4x4/S via software "drivers." Basically, a software driver is a spe-
cial dedicated program that makes a MIDI interface accessible to
any Windows application.
MIDI interface drivers are supplied by the hardware manufactur-
er, the operating system manufacturer, or the application develop-
er. On the included factory diskette, Midiman supplies the
Windows drivers that enable the use of the PORTMAN 4x4/S
with Windows programs that comply with the Windows
Multimedia driver standards.
In the DOS environment, each DOS application requires its own
unique (and usually proprietary) set of drivers. Consequently, the
PORTMAN 4x4/S can only be used with a DOS program if a spe-
cific PORTMAN 4x4/S driver is written for that program. Please
contact the developer of your DOS-based application for PORT-
MAN 4x4/S support.

Windows 3.1 and 3.11 Driver Installation

To install the PORTMAN 4x4/S Windows 3.1x MIDI drivers onto
your system do the following:
1. Start Windows as you usually do.
2. Click open the *Main* group.
3. Click open the *Control Panel*.
4. Click on the *Drivers* icon.
5. Check for a Midiman PORTMAN 4x4/S entry. If one exists,
then the driver is already installed—click on "Cancel" and
close the *Control Panel* -- then go directly to Step 13 to set
up your application. If the PORTMAN 4x4/S driver is not pre-
sent, please continue to Step 6.
6. Click on the "Add" button.
7. Select the "Unlisted or Updated Driver" entry and push the
"OK" button.
18