Care And Maintenance; Specifications - La Crosse Technology WS-8256U Instruction Manual

2) Move the atomic clock closer to the transmitter or place the transmitter
3) Move the units to another location. Interferences from other electrical
"OFL" appears in the outdoor temperature section of the LCD.
Problem:
Solution: 1) Wait until the current surrounding temperature cools down or increases.

CARE AND MAINTENANCE:

• Avoid placing the units in areas prone to vibration and shock as these may cause damage.
• Avoid areas where the units can be exposed to sudden changes in temperature, i.e. direct
sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which
reduces the accuracy of readings.
• When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or
scouring agents.
• Do not submerge the units into water.
• Immediately remove all low powered batteries to avoid leakage and damage. Replace only with
new batteries of the recommended size.
• Do not make any repairs to the units. Please return it to the original point of purchase. Opening
and tampering with the units may invalidate the warranty.

SPECIFICATIONS:

Temperature measuring range
Indoor: +14.1ºF to +99.8ºF with 0.2ºF resolution
-9.9ºC to +37.6ºC with 0.1ºC resolution
("OFL" displayed if outside this range)
Outdoor : -21.8ºF to +157.8ºF with 0.2ºF resolution
-29.9ºC to +69.9ºC with 0.1ºC resolution
("OFL" displayed if outside this range)
again. Make sure the batteries are new and fresh.
closer to the atomic clock. Make sure the clock is at a receivable range
from the transmitter.
devices operating on the same signal frequency (433MHz) may prevent
correct signal transmission and reception.
Current temperature is outside of the measuring range of the transmitter.
The outdoor temperature will be displayed again once the current
surrounding temperature is within the range of the transmitter.
17