SATO MB200i Programming Reference Manual page 66

QR CODE
FUNCTION
Specifies QR Code of 2D code.
FORMAT
<ESC>2D30 (Model 2)<ESC>DSk,n...n
<ESC>2D31 (Model 1)<ESC>DNmmmm,n...n
Print data specification will differ with the following setting. When Normal is specified, omit all following
parameters. When Concatenation is specified, set all following parameters.
The following parameter specifies the quantity of QR code split by concatenation mode to concatenate.
The following parameter specifies the specific quantity of split QR code.
The following parameter specifies the data in Hex character that is calculated from the entire print data
of split QR code.
<ESC>DS: The following setting is only necessary when specifying Manual setting in the Data Setting
mode. The binary specification will still be available, but the data specification command will be
different.
<ESC>DN: The following setting is required when specifying Automatic in the Data Setting mode or
specifying Binary of the Manual setting.
Place anywhere after <ESC>V but before <ESC>Q.
"i" Programming Reference
Unit 4: Standard Command Codes
a = Error correction level
L: 7%
M: 15%
Q: 25%
H: 30%
b = Cell size in dots (01 to 32)
c = Data setting mode
0: Manual
1: Automatic
d = Concatenation mode
0: Normal
1: Concatenation
e = Quantity of partitions by concatenation mode (01 to 16)
f = Sequential number partitioned by concatenation mode (01 to 16)
g = Parity data of Concatenation mode (00 to FF)
k = Enter mode
1: Numeric
2: Alphanumeric
m = Quantity of data (1 to 2953)
n = Print data
4-36
PN: 9001158B