Installing The Fixed Cinewide Base Plate (Prismatic Anamorphic Lens) - Runco XtremeProjection X-200i Installation & Operation Manual

Installation
Installing the Fixed
CineWide Base Plate
(Prismatic Anamorphic
Lens)
To install the fixed CineWide base plate on a X-200i/CineWide with a prismatic
anamorphic lens:
1. Place the projector upside down on a blanket or other soft surface.
2. Secure the CineWide base plate and Ceiling Mount Plate (if used) to the projector with
the three, M4 x 0.7 x 14mm screws provided with the CineWide lens base plate. See
Figure 3-9.
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Figure 3-9. Projector with Whitney (Prismatic) Lens Base Plate - Bottom View
26 Runco X-200i Series Installation/Operation Manual