Dimension Digital Controller; Front Panel Layout; Dimension Digital Controller Front Panel - Runco XtremeProjection X-450d Installation & Operation Manual

System Overview
2.3
DC-300 Dimension
Digital Controller

Front Panel Layout

1
Figure 2-4. Dimension Digital Controller Front Panel
3. PRIMARY VIDEO INPUT
Connect the HDMI Out To Primary Display connector from the Dimension Digital
Controller to this input (see Figure 2-5).
4. PRIMARY SOURCE LED
Lights amber when the projector detects a valid primary video signal from the

Dimension Digital Controller.

5. SECONDARY VIDEO INPUT
Connect the HDMI Out To Sec. Display connector from the Dimension Digital
Controller to this input (see Figure 2-5).
6. SECONDARY SOURCE LED
Lights amber when the projector detects a valid secondary video signal from the
Dimension Digital Controller.
7. POWER INPUT (100 to 240 VAC)
Connect the X-400d/X-450d to power here.
The Dimension Digital Controller provides "left-eye" and "right-eye" video signals and the
OSD menu to the projector. It controls the other system components in response to user
input via the following interfaces:
• Front-panel keypad
• IR remote control unit
• HDMI CEC messages
• Serial commands via RS-232 or TCP/IP
• Ethernet
Figure 2-4 shows the controls and indicators on the Dimension Digital Controller front
panel; the paragraphs that follow describe them.
X-400d/X-450d
16:9/1
2 3
1. RUNCO ICON
Lights blue to indicate that the controller is on or powering up.
2. IR SENSOR
Receives IR commands from the remote control.
standby
HDMI 1
1080i/60
4
8
11 10 9
m
e
n
u
5 6 7 8
Runco X-400d/X-450d Installation/Operation Manual