Autoscope Lens Motor Installation - Runco XtremeProjection X-450d Installation & Operation Manual

Installation
Install Lens Motor: Position the AutoScope Lens Motor as shown in Figure 3-8. Line up
the mounting holes on the lens motor housing with those on the underside of the
projector. Secure the motor to the projector with the four remaining Pan-Head Phillips
screws.
Figure 3-8. AutoScope Lens Motor Installation
After you have installed the AutoScope lens motor, proceed with Mounting the
X-400d/X-450d (page 32).
Runco X-400d/X-450d Installation/Operation Manual 29